Converters and BMS Integration for OGeneral Ducted AC
We provide dry contact and protocol converters so your OGeneral duct AC connects to building systems. We handle MODBUS, KNX, and LAN gateways, set registers and group addressing, and document the points list for handover. We also integrate smart thermostats alongside BMS when required.
Table of contents
Converter types Integration scope Testing and handovers FAQConverter types we install
| Type | Purpose | Notes |
|---|---|---|
| Dry contact I-O | Enable, alarm, filter, maintenance | For local control and safety interlocks |
| MODBUS RTU or TCP | BMS polling and writes | Registers for mode, setpoint, fan, feedback |
| KNX | Home and commercial control | Group addresses for scenes and schedules |
| LAN gateway | Network monitoring | Simple dashboards and remote access |
Integration scope
- Survey and design with point list definition
- Converter selection, cabling, and addressing
- Controller and BMS mapping for cooling and fan
- Alarm and filter status feedback
- Dual control with smart thermostats when requested
Testing and handovers
We test reads and writes, verify setpoints, confirm fan logic, and document registers and group addresses. We provide a clear handover pack for facility teams.
FAQ
Can you integrate new and existing OGeneral duct AC
Yes. We integrate both new and existing systems. We review controllers and provide the correct interface for BMS or smart control.
Do you provide a documented point list
Yes. We include registers, ranges, and group addresses for smooth operations.
